testing notes

Tensile strength Test of Rebar Coupler |IS 1608

Tensile strength Test of Rebar Coupler

Tensile strength Test of Rebar Coupler The tensile strength test of rebar coupler carried out in accordance with IS 1608. A tensile test on an un-spliced specimen from the same bar used for the preparation of spliced specimen shall be performed to establish the actual tensile strength of the reinforcing bar. For the calculation of …

Tensile strength Test of Rebar Coupler |IS 1608 Read More »

Specific gravity test of soil, IS 2720-Part 3

Determination of Specific gravity of soil IS 2720-Part : 1980

Specific gravity of soil by density bottle ( Pycnometer) Determination of specific gravity of soil particles of both fine-grained and coarse-grained soils by using a pycnometer. The specific gravity of soil will help in the calculation of void ratio, degree of saturation, and other different soil properties. Test Standard : IS 2720-Part 3/Sec1: 1980, Reaffirmed …

Specific gravity test of soil, IS 2720-Part 3 Read More »

Fineness test of Cement by dry sieving method 90 micron sieve

Fineness test of cement by dry siveing

CEMENT TEST OF CEMENT BY DRY SIEVING 90 micron is sieve for Fineness test of Cemet by dry sieving method Test standard : IS 4031-Part 1 Test Apparatus : Balance of accuracy 0.01gm with capacity of minimum 10gms.  90micron IS Sieve. Nylon brush. Stopped jar. Tray. Testing Procedure : Agitate the sample of cement to …

Fineness test of Cement by dry sieving method 90 micron sieve Read More »

Aggregate Impact Value Test IS 2386-Part 5: 1963

Aggregate impact value test

DETERMINATION OF IMPACT VALUE OF COARSE AGGREGATE Test Standard : 2386-Part IV: 1963 Test Apparatus: Impact test apparatus with free-falling hammer of 13.5 to 14kg with a height of fall of 380±5mm, with supporting means of hammer whilst fastening or removing the cups. Cylindrical steel cup of internal diameter 102mm and 50mm deep; IS sieves …

Aggregate Impact Value Test IS 2386-Part 5: 1963 Read More »

Aggregate Testing | Ten Percent fine value of Coarse Aggregate IS 2386 -Part 4

TEen percentage fine value test

DETERMINATION OF TEN PERCENT FINES VALUE OF COARSE AGGREGATE Test standard: IS 2386 -Part IV: 1963 Purpose of Test: Ten percent fines value is a measure of the resistance of aggregate crushing subjected to loading and it is applicable to both weak and strong aggregate. Test Apparatus : 15cm diameter open ended cylinder with base …

Aggregate Testing | Ten Percent fine value of Coarse Aggregate IS 2386 -Part 4 Read More »